(720) 706-9464
Finishing your basement in Brighton, CO? The electrical is what makes or breaks the whole project. A space that was just storage last month needs dedicated circuits, outlets, recessed lighting, arc-fault protection, and often a panel or subpanel upgrade to carry the new load. Ace Electric handles the full basement electrical remodel with clean, code-compliant work, permits pulled, and clear upfront pricing. Call our project manager directly and get straight answers before any work begins.
Modern basement finishes need dedicated circuits, proper outlet spacing, and lighting that does not make the space feel like a basement. Current code requires arc-fault (AFCI) protection on most basement circuits, GFCI protection near any wet bar or bathroom, and if your basement will include a bedroom, specific rules for smoke and carbon monoxide detectors, egress lighting, and outlet spacing. Get any of it wrong and you fail your City of Brighton inspection.
We have done basement electrical remodels all over Brighton, from the historic homes near downtown and Main Street to newer builds in Brighton Crossing and Bromley Park. Brighton is the Adams County seat and a growing city of about 40,000 people, so we see everything from 1970s finished basements to brand-new homes in School District 27J neighborhoods. Every basement is different, but the goal is the same: electrical that works for how you actually use the space, with outlet locations planned around your furniture, not just code minimums.
Brighton has plenty of homes built in the 60s, 70s, and 80s. Those basements often have electrical that's either undersized or just plain outdated. Older homes around Main Street and the original Brighton neighborhoods usually have smaller panels - 100 amp or sometimes even 60 amp service. We do a lot of panel upgrades alongside basement finishes. Makes sense to do it all at once since the walls are open anyway. A 200 amp panel gives you room for the basement plus future stuff like an EV charger or hot tub.
The rough-in phase is when all the wiring gets run through the walls before drywall goes up. This is honestly the most important part of any basement electrical remodel. Once drywall is up, adding or moving things gets expensive and messy.During rough-in we install all the wire runs from the panel to each outlet, switch, and light location. We also run low voltage wiring for ethernet, coax, and speaker wire if you need it. Brighton uses state electrical inspectors, and they want to see the rough-in before anything gets covered up. We emphasize working with the homeowner and framer to make sure everything is in the right spot before inspection. Common mistakes we fix for other contractors include boxes at wrong heights and not enough circuits for the actual use. A basement home theater needs more than code minimum.
Every basement project in Brighton is a little different. Maybe you're building a home gym and need 240V for a sauna. Maybe there's a wet bar in your kitchen that needs GFCI outlets and under-cabinet lighting.
Custom electrical installation means we figure out exactly what your basement needs - not just slap in the minimum to pass inspection.
Home theaters need outlets behind the TV at the right height and in-wall speaker wire. Basement kitchenettes need GFCI protection near water and dedicated circuits for appliances.If you're making a legal rental unit or ADU in your basement, electrical requirements are more involved.
Separate smoke detection, proper egress lighting, sometimes a sub-panel depending on the setup. We know what Brighton and Colorado require for these projects.
Finishing a basement is one of the most common projects we take on as an electrician in Brighton, CO, and we pull the permits and handle inspections from rough-in through final.